My question is - can I please revert somehow to Map Pilot 1.4.x or 1.5? Otherwise I just physically not able to fly my drone for orthophotoplans missions. I'm pretty sure the issue is not in my 'old' flying setup but in the latest versions of Map Pilot. This inconvenience repeated 7-8 time with 2 batteries during 2 days so I didn't completed the task :-( With version 1.4.x upload was immediate and NO problems detected. Also mission uploading procedure takes minutes to wait before it starts. So I have to RTH and prepare everything from the beginning.

I start Map Pilot again, it connects to the flying it's mission Phantom but images no longer taken. Now in May 2017 I flew with the same firmware and hardware DJI, iPad Mini 2 and IOS 9.3.5 setup but with Map Pilot 2.4.6 and could't complete a single mission on a small area with one battery and 6 min of planned mission fly time!!! The App suddenly closes on 2-3 min after mission start while Phantom on the air. Only iPad I used daily for various purposes and updated Map Pilot several times till the last version 2.4.6 just because it notified me about new versions. No errors, no drops, no missed image points!! Since Nov 2016 till May 2017 this DJI setup was stored in a its backpack under my table without usage. Last year from March 2016 to October 2016 with Map Pilot v.1.4.x I flew happily and smooth my Phantom 3 Advanced on my IPad Mini 2 IOS 9.3.5. You both need to make sure you are operating on the latest firmware for your aircraft. You can turn the timer limit off in the settings to see if that fixes it for you. Kanu: It sounds like you are having an issue at the default timer expiration which is set to 17 minutes. If you are hearing a beeping sound, your signal is too low. What are the requirements for the IFD Trainer Xp app I have two iPads, one mini (Model MD965LL/A) running iOS 9.3.5 and the other a full size iPad (Model. Make sure your sound is on and the volume is up. Being on and 'in contact' is very different that having a solid signal. The trade off is that Map Pilot requires an active connection for adding this level of control. This is why we jump through all sorts of hoops to make it so all images get taken while traveling the same speed. That will cause lots of finished product accuracy issues due to the camera's rolling shutter.

Other apps simply set a timer and off you go. This is indicative of trying to image too quickly or a camera issue that is not Map Pilot related. There seems to be two and a gap, two and a gap. The spacing in your imaging locations is not caused by multiple flights. Hide IP address: Safari automatically protects your IP address from known trackers. Turn this option off to allow cross-site tracking. Prevent Cross-Site Tracking: Safari limits third-party cookies and data by default. Try turning your SD Card speed down to Class 10 (3 seconds). Go to Settings > Safari, then turn any of the following on or off. It it is dropping the grey dots and no photo is being taken then you have a camera issue going on.

Fltplan go for ios 9.3.5